i just plugged in my e7300 for a 4ghz quick run and tested it on orthos. after i tested in orthos, core 1 fails after just 1 sec at 1.35v. i bumped up the vcore all the way up to 1.45v just so it passes the stress test for sure but to my surprise, core 1 still fails after only 1 sec. this means i have some other settings wrong. what should i set the vnb, vtt, GTL, and memory divider to be? here is my current settings:

Code:
Processor:  e7300
Ai Overclock Tuner: Manual
Ratio CMOS Setting: 10
FSB Frequency: 400
CPU Clock Skew: Auto
NB Clock Skew: Auto
FSB Strap to North Bridge:  266 MHz
DRAM Frequency: 1003 MHz

DRAM Timing Control: Manual
1st Information: 5-5-5-15

DRAM Static Read Control: Disabled
DRAM Read Training: Disabled
MEM. OC Charger: Enabled
Ai Clock Twister: Auto
Ai Transaction Booster: Auto

PCIE Frequency: 101

CPU Voltage: 1.3750
CPU PLL Voltage: 1.53975
FSB Termination Voltage: 1.35175
DRAM Voltage: 2.01200
North Bridge Voltage:  1.35175
South Bridge 1.5 Voltage:  1.50000
South Bridge 1.1 Voltage: 1.10000: 

CPU GTL Reference (0): +30mV
CPU GTL Reference (1): Auto
CPU GTL Reference (2): +30
CPU GTL Reference (3): Auto
NB GTL Reference:  Auto
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto

Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled