***Asus Rampage III Extreme Owners Thread***

[Reflex1]

Which CPU are you using?
And please use BIOS template to specify your settings.

These are my settings, but it doesnt post with this even though they are just rated ram speeds. they are not my 24/7 settings, im just testing my ram to see how much they will oc. I use bios 0901 atm

edit: im using a i7 930 cpu.

Target CPU Frequency		3003MHz
Target DRAM Frequency		2006MHz

LN2 Mode:			Disabled***
QPI Loadline Calibration:	Disabled***

Sync Mode			[Enabled]
AI Overclock Tuner		[Manual]
OC From CPU level Up		[Auto]

2D Performance Booster		[Disabled]
CPU Ratio Setting		[21.0]
CPU Turbo Power Limit		[Disabled]

>CPU Configuration----------------------------
CPU Ratio Setting		[21.0]
C1E Support			[Disabled]
Hardware Prefetcher		[Enabled]
Adjacent Cache Line Prefetcher	[Enabled]
Intel(R) Virtualization Tech	[Enabled]
CPU TM Function			[Disabled]
Execute Disable Bit		[Enabled]
Intel(R) HT Technology		[Enabled]
Active Processor Cores		[All]
A20M				[Disabled]
Intel(R) SpeedStep(TM) Tech	[Disabled]
Performance/Watt select		[Power]
Intel(R) C-STATE Tech		[Disabled]
C State package limit setting	[Auto]
C1 Auto Demotion		[Enabled]
C3 Auto Demotion		[Enabled]
----------------------------------------------

BCLK Frequency			[143]
PCIE Frequency			[100]
DRAM Frequency			[2006]
UCLK Frequency			[auto]
QPI Link Data Rate		[auto]

Memory Configuration Protect	[Disabled]

>DRAM Timing Control--------------------------
CAS# Latency		      8	[8]
RAS# to CAS# Delay	      9	[9]
RAS# PRE Time		      8	[8]
RAS# ACT Time		     24[24]
RAS# to RAS# Delay	      4	[Auto]
REF Cycle Time		     72	[Auto]
WRITE Recovery Time	     10	[Auto]
READ to PRE Time	      6	[Auto]
FOUR ACT WIN Time	     24	[Auto]
Back-To-BackCAS# Delay	      0	[Auto]

Timing Mode		     1N	[1N]
Round Trip Latency on CHA    59	[Auto]
Round Trip Latency on CHB    61	[Auto]
Round Trip Latency on CHC    62	[Auto]

WRITE To READ Delay(DD)	      8	[Auto]
WRITE To READ Delay(DR)	      8	[Auto]
WRITE To READ Delay(SR)	     18	[Auto]
READ To WRITE Delay(DD)	      7	[Auto]
READ To WRITE Delay(DR)	      7	[Auto]
READ To WRITE Delay(SR)	      7	[Auto]
READ To READ Delay(DD)	      7	[Auto]
READ To READ Delay(DR)	      6	[Auto]
READ To READ Delay(SR)	      4	[Auto]
WRITE To WRITE Delay(DD)      7	[Auto]
WRITE To WRITE Delay(DR)      7	[Auto]
WRITE To WRITE Delay(SR)      4	[Auto]
----------------------------------------------

CPU Differential Amplitude	[Auto]
CPU Clock Skew			[Auto]
IOH Clock Skew			[Auto]
------------ Extreme Engine Digi+ ------------
Digi+ PWR Mode			[T-Balanced]
PWR Volt. Control		[Auto]
Load-Line Calibration		[Full]
CPU Voltege OCP			[Enabled]
CPU PWM Frequency		[Auto]

Extreme OV			[Enabled]*
Extreme OC			[Auto]

CPU Voltage		1.25	[1.25]
CPU PLL Voltage 	1.35	[1.35150]
QPI/DRAM Core Voltage	1.40	[1.40]
DRAM Bus Voltage	1.654	[1.65625]

>DRAM REF Voltages----------------------------
DRAM DATA REF Voltage on CHA	[Auto]
DRAM CTRL REF Voltage on CHA	[Auto]
DRAM DATA REF Voltage on CHB	[Auto]
DRAM CTRL REF Voltage on CHB	[Auto]
DRAM DATA REF Voltage on CHC	[Auto]
DRAM CTRL REF Voltage on CHC	[Auto]
----------------------------------------------

IOH Voltage		1.111	[Auto]
IOH PCIE Voltage	1.508	[Auto]

ICH Voltage		1.111	[Auto]
ICH PCIE Voltage		[Auto]

*QPI Voltage OCP		[Enabled]
*IOH Voltage OCP		[Enabled]
*DRAM Voltage OCP		[Enabled]
*QPI PWM Frequency		[Auto]
*IOH PWM Frequency		[Auto]
*DRAM PWM Frequency		[Auto]

---------- Spread Spectrum Control -----------
CPU Spread Spectrum		[Disabled]
DRAM Spread Spectrum		[Disabled]



***on-board jumper dependant