Quote Originally Posted by N.I.C View Post
I have exact the same problem with Ghostleader, but with my CSX D9GTR 2x2... I cannot make them work at 1800mhz/ and the cpu at 450 FSB...At 1601mhz all seems to be ok... I am with 1201 bios... I've tried both 333 and 400 strap, no luck..I have the ram at A2/B2..I've tried messing with skews but no luck again, CPU NB skews Delay 100 and CLK A2 advance 50, CLK B2 advance 25
Well I have to expand my theory and add that RE donīt like 2Gb modules ~1800MHz.
BTW I didnīt know that they make/made 2Gb moduls (dubble side) with Micron D9GTR.

I donīt know what to do to make my 2x2 to work on this RE.
I have a Gigabyte EP45T-UD3P inbound, gonna test the same on that board to se if it works.


Quote Originally Posted by Crazymilk View Post
Thank you so much Ghost. Yep this Corsair RAM is the v4.1 that uses the Samsung Chips.(I would think the same as your Transend)

I wil give your suggestions ago and see what happens, no matter what I have tried today I get massive amount of errors at 9mins in Memtest so fingers crossed .

Just a thought.. This RAM has the XMP profile..I hate using these preset profiles but what about if I select that XMP profile and then check in the BIOS (before I load in to the OS) to see what that sets the timings at???
Then didtch the XMP profile and manually put in the XMP profile settings...as I say its just a thought
Yopu can try it but I doubt if going to work.

My Trencend are also XMP but it doesnīt work (neither did my Dominator 1800C7D) so I set it manual in bios.