Quote Originally Posted by NaeKuh View Post
well if u use a eK bridge, then it wont matter.

But basically attach both ports to both cards.
The top card only has a port open on 1 side, while the two are open on the bottom.

The bottom card has 2 ports which are open on top, and 1 open on the bottom.

The F parallel means as it says.
Say u have 2 F's, but the second one is flipped.
That way u got 2 L's feeding in even paths, so its a true parallel.

But as i said if ur using an EK bridge, its moot, if not, then i would use some dplugs as bridges.



GRRRR Edit..
Seeker, is that the proper orientation ur going to have this unit?
So It looks like a TJ-07 with an inveresed mobo plate?
So can i assume u will have a plate below that cpu?



Use that bottom plate to hide your routing.

And try to uniform the ups and downs like so.

So from pump -> Cpu -> back under the plate -> to another pump for redundancy -> board block -> gpu -> gpu->back again under the plate -> Res -> Pump -> cpu.
GRRRR Edit..
Seeker, is that the proper orientation ur going to have this unit?
So It looks like a TJ-07 with an inveresed mobo plate?
So can i assume u will have a plate below that cpu?

NaeKuh,
The MB will be inverted just like the last (TJ07) build. I try to hide everything under the midplate, but you can only hide so much! Two pumps, two rads, the tubing, the wires and not to mention the PSU.

Currebrly, Alexandros is winning for the $1,000.00 gift certificate for H20 cooling parts, less shipping

As always, thanks for your input!