Suggestions for My Loop and Tube Routing

[NaeKuh]

Which ones? Have a link?
Thanks

well if u use a eK bridge, then it wont matter.

But basically attach both ports to both cards.
The top card only has a port open on 1 side, while the two are open on the bottom.

The bottom card has 2 ports which are open on top, and 1 open on the bottom.

The F parallel means as it says.
Say u have 2 F's, but the second one is flipped.
That way u got 2 L's feeding in even paths, so its a true parallel.

But as i said if ur using an EK bridge, its moot, if not, then i would use some dplugs as bridges.



GRRRR Edit..
Seeker, is that the proper orientation ur going to have this unit?
So It looks like a TJ-07 with an inveresed mobo plate?
So can i assume u will have a plate below that cpu?



Use that bottom plate to hide your routing.

And try to uniform the ups and downs like so.

So from pump -> Cpu -> back under the plate -> to another pump for redundancy -> board block -> gpu -> gpu->back again under the plate -> Res -> Pump -> cpu.