Instead of sucking a bunch of hot air, try this bong instead!

[Naja002]

Most of the components in the system use NPT fittings. So I'll be able to connect the following components without tubing between them:
1.) Reservoirs = Filter Housings
2.) Mazzei Injector = Vacuum Pump
3.) Danner Hy-Drive 4800 GPH liquid-coolant pump.

Right. The mazzei connects directly to both the res's and actually connects the res's together. Got it. The pump has to be connected somehow, so I gather from your comment below that you will be using PVC and some tubing for the most part, correct?

Is that 4800 GPH a typo? Nevermind, I googled it.

With the use of NPT adapters, most of these will connect directly. If I remember correctly, you don't use solder, brazing or similar means to connect PVC!

Right. PVC is welded.

If I don't go the sub-zero route as we've discussed before, the use of other connecting techniques won't be required. I don't know yet. I haven't made up my mind.

Shingoshi

So, you are expecting to be able to achieve sub-zero temps with your "boil via vacuum" cooling system, correct? That sub-zero C or F? And at what load?


Are you going to be incorporating "ultrasonics" into this system?