Hi guys I have an Ultra 1000w psu it's modular of course but I was wondering about the 24 pin atx motherboard cable. I am going to sleeve my system right up as described in this killer guide.

Should I build another 24 pin male to male cable (if so any pointers) or do you know where I can find a male to male 24 pin ATX pre-built (ideally black).

I am building a tiny little Danger den Water Box system and the psu is right next to the motherboard so the cable management will only be 4 inches and I don't want to carve up the original atx any ideas?

I just hoping I could keep the original cables just that, original.

Thanks

btw I am in Canada if that helps. It almost never does.