Madness-Murder Jr

[shazza]

Shazza,

You know me, its scotch, smokes and cooking time! Here is the fitting http://www.sidewindercomputers.com/bishg14sidse.html and it is beautiful and it can work with a single or a dual slot configuration due to the dual O-Rings. This fitting is hard to describe, however someone at BP has their stuff together! Now, help me with the tubing problems! Everyone knows that you are the tubing King, Queen and all other Royalty when it comes to tubing....period, end of story!

seeker.

Good deal ... I've gotta couple of those fittings in my stash.


Re the loop; my first thought was "turn the res upside down" (okay, that should give you some insight as to why I'm always excited when I get something to actually work).

If you're talking about the going from the CPU block to the bottom GPU block, then I don't see how you do it without some 45s or dual45s (for that semi-90 degree bend flexibility).

Can you exit the CPU, route the tubing to the top GPU inlet, come out the bottom GPU, into the res? This would make a pretty good flow, if you swap the SLI connector plug to the other side. Might still require a 45 from the CPU.

I don't think there would be an issue with flow traveling down the GPUs instead of up ... not like gravity is going to rush all the water out of the top (but then, I'm no physicist). My inclination would be to push the water flow up the GPUs, but I'm not sure it will make much difference to temps.

If any of this makes sense to you, you haven't had enough scotch