RAM overclocking only ( 4x 1GB Kingston HyperX PC9600 ram kits ).



Booted from bios at 420fsb, bios set 3:5, DDR2-1400, 5-5-5-18-AUTO's, tRD 6,
VTT 1.34, NB 1.44, DIMM 2.36 (memtest with DOS progarm at VTT 1.30, NB 1.36, and DIMM 2.30)



ran a 4x SuperPi 8MB to test system memory and overall stability of the system just a little bit before i continue to overclock the ram kit higher.
also using ET6 and Memset programs to up vDimm to 2.44v and increase tRFC value.



then SetFSB to 445fsb and at DDR1484. and this was about the end of using tRD 6 and this voltage settings.
if i let the tRD value and rest of memory timings loose and use more volts in NB and at the dimms, this ram kits probably can go higher.



soory in advance if you feel there is no point in posting this overclock info on here.
and i would just like to add a word of warning anyway, doing this can damage your hardware or installed Windows.