Thanks for the comments Guys.


Quote Originally Posted by -Gab View Post
That's right

Well, I have two more questions.

I read the thread again but could not find anything about the precise kind of tape you used to attach the window. Have I missed anything, and if not, would you share this secret with us?

I have the same question concerning the stuff you used to remove the Silverstone logo, have you asked your friend if it was available as a consumer product?
For the window adhesive, there are lots of products that do the job nicely. 3M make a variety of thin, two sided tape that stick like sh|t to a blanket.

As for the logo removal; I forgot that I only responded to Evil by PM regarding that. I asked my dude and he didn't tell me if its avaiable as a consumer product, but he did tell me that the active component is HIGHLY hazardous to not only your health, but the health of your future offspring. Needless to say, I was horrified. The bottom line is that I'm actively looking for a solution that is a lot less toxic. Removing Silverstone logos isn't worth dying for - or producing children with gills.


Quote Originally Posted by disruptfam View Post
Charles i'm interested on what way you setup airflow direction in the bottom section of fc's rig.
The air comes in through the side with the PA120.3 (right side) assisted by two fans attached to the inside of the rad - pulling. An inch or so away is the PA120.2 which has two fans on the outside (left side) - pulling through the rad and out. What FC chooses to do with the warm air at this point is up to him.


Quote Originally Posted by GrossmeisterB View Post
Yeah, I allready phones the german Techflex-people, they were very helpful, and he said that normally this ain't a problem, but my order was cut allready and packaged, so no way to send it back...but I think if Charles used Flexo PET as well, it can't be THAT bad...
w3rd.

You'll be fine with the Flexo PET.