Quote Originally Posted by turtletrax View Post
The bow makes mounting alittle bit harder as I think I got a drop on two cores and alittle higher temps on the other two. I thought I had tightened the nuts on the mounting bolts enought but one came loose (enought) to spin when I went to tighten the block down to maximum. Probably got a bit of an uneven mount.
I made several mounts to get my temps within a couple of degrees of each other, one thing I noticed on my board was it was possible to over tighten the block which resulted in board flex making the PWM squeal & the rig would randomly re-boot passably due to the PWM's overheating.

I don't think tightening the block down until the springs or spacers bottom is good I think its way too tight.

I now use a back plate on the board & just apply light block mounting pressure & all is good.

I think I need to get rid of the HE 120.3 and go PA 120.3. The HE needs much more fan than I am giving it. Will see when I get the bowed, nozzled, sealed and MX-2'd Fuzion on my G0
The PA is awesome do it you know you want to

CN