Hey guys. Closing in on 4x1GB stable and 4Ghz with my G0 Q66, but I need 2.31vdimm to do so. I only needed 2.15v max to get 1066 on my 680i with 4GB
This is on the 9/13 Bios
Here are my settings. LMK if there is anything you can suggest.
Edit: Quad SuperPi 32M just crapped out. No matter what I try I cannot get 4X1G stable. I have tested each kit seperately and know them as working.Code:CPU Feature - Thermal Management Control: Disabled - PPM(EIST) Mode: Disabled - Limit CPUID MaxVal: Disabled - CIE Function: Disabled - Execute Disable Bit: Disabled - Virtualization Technology: Disabled - Core Multi-Processing: Enabled Exist Setup Shutdown: Mode 2 CLOCK VC0 divider: AUTO CPU Clock Ratio Unlock: Enabled CPU Clock Ratio: x9 - Target CPU Clock: 4005 CPU Clock: 445 Boot Up Clock: Auto DRAM Speed: 333/800 - Target DRAM Speed: 1069 PCIE Clock: 110mhz Voltage Settings CPU VID Control: 1.6v CPU VID Special Add: Auto DRAM Voltage Control: 2.31 SB 1.05V Voltage: 1.07v SB Core/CPU PLL Voltage: 1.55v NB Core Voltage: 1.61 CPU VTT Voltage: 1.60 Vcore Droop Control: Disabled Clockgen Voltage Control: 3.45v GTL+ Buffers Strength: Strong Host Slew Rate: Weak GTL REF Voltage Control: Disable x CPU GTL1/3 REF Volt: 115 x CPU GTL 0/2 REF Volt: 114 x North Bridge GTL REF Volt: 117 DRAM Timing - Enhance Data transmitting: AUTO - Enhance Addressing: AUTO - Channel 1 CLK fine delay: AUTO - Channel 2 CLK fine delay: AUTO CAS Latency Time (tCL): 5 RAS# to CAS# Delay (tRCD): 5 RAS# Precharge (tRP): 5 Precharge Delay (tRAS): 15 All Precharge to Act: 5 REF to ACT Delay (tRFC): 32 Performance Level: 7 MCH ODT Latency: AUTO Write to PRE Delay (tWR): 12 Rank Write to Read (tWTR): 10 ACT to ACT Delay (tRRD): 3 Read to Write Delay (tRDWR): 8 Ranks Write to Write (tWRWR): AUTO Ranks Read to Read (tRDRD): AUTO Ranks Write to Read (tWRRD): AUTO Read CAS# Precharge (tRTP): 2 ALL PRE to Refresh: AUTO PCIE Slot Config: 1X 1X CPU Spread Spectrum: Disabled PCIE Spread Spectrum: Disabled SATA Spread Spectrum: Disabled
Arg
Reply With Quote
Bookmarks