***Official***Z68X/P67A-UD7 Club/Discussion/Info**

[nijel]

Reflash with FlashSPI, and do a 30 second clear cmos after the flash is complete (power off, unplug PSU, press case button while unplugged, then short the clear cmos jumpers for 30 seconds).

This will fix that completely.

Nothing helped even after power disconnect/battery removed overnight. This morning the board didn't want to start, no fans no anything, like there wasn't any power. Disconnected the 24-pin ATX connector, tested the PSU (green<->black shorting-OK) and started after that. But still identifies as Z68 board. Flashed it with F4 bios from Giga site (using my own modded F4) and that was the fix. Back to my modded F4 and all is good. Apparently my modded F4 bios doesn't override some chip arias or something...

Ooh, and why after no power/no battery overnight the power button and power LEDs are still on?!?! Even with 24-pin ATX disconnected... W(here)TF is power coming from!?!?!?