Quote Originally Posted by C-N View Post
I have the original B2 board flashed with F3G JZ (B3 Bios)

I noticed CPU-Z & ET didnt always change vcore or vdimm if you used ET6 to adjust voltages although my DMM did register some change & my load temps in LinX went up/down with vcore adjustment. Only way I found to get CPU-Z/ET 6 to register correctly was PSU power down..... V strange but it may have something to do with GB trying to eliminate boot loops & removing the boards ability to set things on a soft power down I guess.

I havent had any problems with int pll with my 2500K I need it to pass x49 & I want x50 so its always been on.



Same as older 3 level BIOS's, no droop set 1.355 BIOS get 1.39~1.4 LinX load with level 1



Thanks for posting links to the B2~B3 mod BIOS's, great work as usual my friend
<------C_N ?
You're using a B3 BIOS (crossflashed), and you're getting RISE at load ??


1.355v BIOS LLC1 for me gives 1.33'ish load... I only get that rise you have if I'm using LLC2.

Did you try a 60 second cmos clear after you flashed? (or if you haven't, you can still do that now, anyway, without reflashing)
(I always flash with flashspi, power off, unplug PSU, wait 60 seconds, press cmos clear button for about 30 seconds, etc...)

This can only mean that the LLC rise in the B2 board is a hardware problem, then....and not BIOS related O_O