Gigabyte GA-P67A-UD5 Discussion Thread

[C-N]

Ive ran the jz since the 1st-2nd day and have never unplugged my PSU although I did have some reboots in the beginning and Im leaning towards more of n00bness to Intel and with the help of everyone on the thread... c-n / falkentyne / Stasio ive pretty well and went back to my notes and feel it was my setting the pll enabled was the issue on earlier bios. now with the new f3G im able to again enable it and lower my voltages even more so you might be onto something there. C-N your running the original MB or did you get a B3? also im curious as to the setting on board as to the software how much of a gap in voltages did you read? Is it better to have the PLL enabled or disabled for normal usage?\ barring any problems..

Stasio Ive noticed that the F3G has been removed from the beta thread is there or was there and issue with it or was the G just removed?
GA-P67A-UD5-B3 - F3

I have the original B2 board flashed with F3G JZ (B3 Bios)

I noticed CPU-Z & ET didnt always change vcore or vdimm if you used ET6 to adjust voltages although my DMM did register some change & my load temps in LinX went up/down with vcore adjustment. Only way I found to get CPU-Z/ET 6 to register correctly was PSU power down..... V strange but it may have something to do with GB trying to eliminate boot loops & removing the boards ability to set things on a soft power down I guess.

I havent had any problems with int pll with my 2500K I need it to pass x49 & I want x50 so its always been on.

Hmm,
C_N how's the vdroop for you on F3g jz?

Same as older 3 level BIOS's, no droop set 1.355 BIOS get 1.39~1.4 LinX load with level 1

Previous BetaBIOS

Thanks for posting links to the B2~B3 mod BIOS's, great work as usual my friend