Gigabyte GA-P67A-UD5 Discussion Thread

[AMD_Freak]

Guys i think i may have been a little hasty with my summery of the jz bios, i decided to give it another go & did a fresh install. The thing is even though gb have adjusted the vdimm to better represent real vdimm this was not my long run prime stabiliry problem. What i have found partly due to not believing what im seeing combined with falkentyne's constant mention that jz is good & fixed his cold boot problem is jz kind of locks voltages & unless you psu power off after each change it wont register voltages properly in software & is therefore unstable. My board is now running fine on this bios.

Ive ran the jz since the 1st-2nd day and have never unplugged my PSU although I did have some reboots in the beginning and Im leaning towards more of n00bness to Intel and with the help of everyone on the thread... c-n / falkentyne / Stasio ive pretty well and went back to my notes and feel it was my setting the pll enabled was the issue on earlier bios. now with the new f3G im able to again enable it and lower my voltages even more so you might be onto something there. C-N your running the original MB or did you get a B3? also im curious as to the setting on board as to the software how much of a gap in voltages did you read? Is it better to have the PLL enabled or disabled for normal usage?\ barring any problems..

Stasio Ive noticed that the F3G has been removed from the beta thread is there or was there and issue with it or was the G just removed?
GA-P67A-UD5-B3 - F3