Quote Originally Posted by truehighroller View Post
I have mine at 4.2 now. It's fine once you stick a little fan on the ones right above the CPU. If you don't have one on yours and you do benching I'm willing to bet yours get hot as well or if not to bad right now, then when you start reaching 4.8GHz I bet they do. I posted my settings a page back. Here are my settings again since this is a new page and probably every one will miss them.


Code:
******************************
MB Intelligent Tweaker(M.I.T.)
******************************
Robust Graphics Booster ..............: [Turbo]
CPU Clock Ratio ......................: [8X]
x Fine CPU Clock Ratio................: +0.5

>>>>> Standard Clock Control
CPU Host Clock Control................: [Enabled]
x CPU Host Frequency(Mhz).............: [495]
PCI Express Frequency(Mhz)............: [100]
C.I.A.2...............................: [Disabled]

>>>>> Advanced Clock Control..........:
CPU Clock Drive.......................: [1000mV]
PCI Express Clock Drive...............: [800mV]
CPU Clock Skew........................: [ 0ps]
MCH Clock Skew........................: [ 50ps]

******** DRAM Performance Control ********

Performance Enhance...................: [Turbo]
MCH Frequency................: 333
System Memory Multiplier (SPD)........: [2.40B]
Memory Frequency(Mhz).................: 1188
DRAM Timing Selectable (SPD)..........: [Manual]

>>>>> Standard Timing Control
x CAS Latency Time................5...: [ 5]
x tRCD ...........................5...: [ 5]
x tRP.............................5...: [ 5]
x tRAS...........................18...: [18]

>>>>> Advanced Timing Control.........: [Press Enter]
(All Auto here)

>>>>> Channel A Timing Settings.......: [Press Enter]
x Static tRead Value............. (8)

(All Auto in Between)

x DDR Write Training..................: Disabled

>>>>> Channel A Driving Settings......: [Press Enter]
x Driving Strength Profile............: [1200MHz]

(All Auto in Between)

>>>>> Channel B Timing Settings.......: [Press Enter]
x Static tRead Value.............    (8)

(All Auto in Between)

x DDR Write Training..................: Disabled

>>>>> Channel B Driving Settings......: [Press Enter]
x Driving Strength Profile............: [1200MHz]

(All Auto in Between)

****** Motherboard Voltage Control ******


-----------------------------------------------
>>> CPU
Load-Line Calibration.................: [Enabled]
CPU Vcore.....................: [1.37500V] Actual Idle [1.344] Actual Load [1.328]
CPU Termination........1.200V.........: [1.420V]
CPU PLL................1.500V.........: [1.570V]
CPU Reference..........0.760V.........: [.939]
>>> MCH/ICH
MCH Core...............1.100V.........: [1.52V]
MCH Reference..........0.760V.........: [.899]
MCH/DRAM Reference.....0.900V.........: [.970]
ICH I/O................1.500V.........: [1.500V]
ICH Core...............1.100V.........: [1.200V]
>>> DRAM
DRAM Voltage...........1.800V.........: [2.00V] 
DRAM Termination.......0.900V.........: [.850]
Channel A Reference....0.900V.........: [Auto]
Channel B Reference....0.900V.........: [Auto]

(All CPU Features Turned Off)
Did you test he DRAM Term. and the MCH/DRAM Term. up and down like you did the CPU/MCH Ref's?