UnOfficial Asus Rampage II Extreme Thread

[reygjabla]

Any ideas as yet on

http://www.xtremesystems.org/forums/...postcount=3252

Try the settings below but bear in mind that this is not absolute settings for your set up.


CPU configuration
CPU Ratio Setting - 20
C1E Support - Disable
Hardware prefetcher - enable
Adjacent Cache line prefetcher - enable
Intel Virtualization tech - enable
CPU TM Function - Disable
Execute Disabled bit - enable
Intel HT Technology - enable
Active Processor Cores - all
A20M - disabled
Intel Speedstep tech - Disable
Intel Turbo Mode tech - Disable
Intel C-STATE tech - disabled
BCLK frequency - 200
PCIE frequency - 100
DRAM frequency - DDR3 1603MHz
UCLK frequency - auto
QPI frequency - auto

Dram timing control all auto
1st information - Insert Timings Here in X-X-X-XX format as specified in your particular Memory kit.eg. 8-8-8-24
EPU II phase control - full phase
Load-line calibration - enable
CPU differential amplitude – 800mv
Extreme OV - disabled
CPU Voltage - 1.3
CPU PLL voltage - auto
QPI-Dram voltage - 1.3
IOH voltage - 1.13xx
IOH PCIE voltage - auto
ICH voltage- auto
ICH PCIE voltage - auto
DRAM Bus voltage – 1.64xxv
DRAM REF voltage - auto

Debug mode - string
Keyboard TeakIt comtrol - disabled

CPU spread spectrum -Disable
PCIE spectrum - Disable
CPU clock skew - auto
IOH clock skew - auto

Do a 20 run of Linx and monitor temp using both Core Temp and Real Temp and take a screen shot after the bench so we can try to determine what needs to be done.