Quote Originally Posted by Patrickclouds View Post
which way goes the refrigerant in your evap?
did you braze the cap tube to the bottem that the refrigerant goes from the bottem of the evap through the spiral or steps up to the outlet.
or did you braze the cap tube to the top so that the refrigerant goes down through the spiral to the bottem and then it passes a small hole to the inner of the evap to go up into the suction line.
Thx Patrick, but I'm not SUCH stupid that I need such clear explanations .

Captube comes to bottom of evap, so it's bottom inlet.


Quote Originally Posted by nigelke View Post
no problem, my english is bad aswell sow I now what you mean.

these Suction Lines, are they easy to install?
Like when you have a Single Stage unit and you want a new Suction Line. Can you just by one of you and replace it. Without having to do alot of work
Not so easy . You need brazing torch, vaccum pump, manifold, and some freon (r507 ) to change suction line .


Quote Originally Posted by Foamy View Post
size of cappilair?
In those two were 300 cm and 350cm of 0.9mm but can be such long as You want .

THANKS!
Regards
Peter