Gigabyte EX58-UD5/Extreme Discussion Thread

[javaneze]

Bluntsmoker or anyone with same setup, have you managed to run the dominators higher than 1600MHz?
I'm currently on these settings, any suggestion on how to achive 10*180 is welcome.

Advanced CPU Features
CPU Clock Ratio*..............................:20
CPU Frequency .....(Ghz)...................:3,600Mhz (3,780Mhz Turbo)
Intel(R) Turbo Boost Tech..................:Enabled
CPU Cores Enabled............................:ALL
CPU Multi Threading..........................:Enabled
CPU Enhanced Halt (C1E)...................:Enabled
C3/C6/C7 State Support....................: Disabled
CPU Thermal Monitor.........................: Disabled
CPU EIST Function............................: Enabled
Virtualization Technology...................: Disabled
Bi-Directional PROCHOT.....................: Enabled (what is this? )

Uncore & QPI Features
QPI Link Speed*..............................:auto
Uncore Frequency...........................:auto
Isochronous Support.......................:Enabled

Standard Clock Control
BCLK Frequency (Mhz)*...................:180

Advanced Dram Features
Performance Enhance......................:Turbo
Extreme Memory Profile (X.M.P.)........:Profile1
System Memory Multiplier (SPD)........:x8
Memory Frequency (Mhz).................:1,440Mhz
DRAM Timing Selectable (sPD) ..........:auto

CPU Voltages
LoadLine Calibration.....................: Disabled
CPU Vcore.................................: Normal (0.93 idle/ 1.168 load by cpuZ)
QPI/VTT Voltage.........................:1.3v

DRAM Voltage............................:1.66v (Defaults 1.66 with xmp enabled)

Everything else missing on auto or default...

I m perfectly fine @3.8 and dont need to get any higher, i just dont feel good about running the sticks @1440 that's below factoy defaults... :/
Is it possible to go 1800MHz (10x180) with lower timings maybe like 9-9-9-24 ?

These are the results i get with the above settings under load...