Gigabyte EX58-UD5/Extreme Discussion Thread

[RCG_Bex]

Can't get 3D Mark to finish.... it stops working on the CPU test....

Really not sure what I need to change to get this stable. If I increase the CPU voltage it BSOD's, QPI increase and it BSOD's, increase PCI-E to 104 or with voltage increased it doesn't boot or boots to loading then black screens....

GIGABYTE GA-EX58-UD4P

>>>> Advanced CPU Features <<<<
CPU Clock Ratio*..............................:20
CPU Frequency .....(Ghz)...................:4,400Mhz (4,600Mhz Turbo)
Intel(R) Turbo Boost Tech..................:Enabled
CPU Cores Enabled............................:ALL
CPU Multi Threading..........................:Enabled
CPU Enhanced Halt (C1E)...................:Enabled
C3/C6/C7 State Support....................isabled
CPU Thermal Monitor.........................: Disabled
CPU EIST Function............................: Disabled
Virtualization Technology...................: Disabled
Bi-Directional PROCHOT.....................: Disabled

>>>> Uncore & QPI Features <<<<
QPI Link Speed*..............................:x36
QPI Link Speed* .............(Ghz)....... :7.59
Uncore Frequency...........................:x16
Uncore Frequency..............(Mhz).... :3,072
Isochronous Support.......................:Enabled

>>>>> Standard Clock Control <<<<
Base Clock (BCLK) Control*..............:Enabled
BCLK Frequency (Mhz)*...................:220
PCI Exxpress Frequency (Mhz)...........:103
C.I.A.2..........................................isabled

>>>>> Standard Clock Control <<<<
CPU Clock Drive (mV).......................:700mV
PCI Express Clock Drive (mV)............:700mV
CPU Clock Skew (ps)........................:0ps
IOH Clock Skew (ps)........................:0ps

>>>> Advanced Dram Features <<<<
Performance Enhance......................:Turbo
Extreme Memory Profile (X.M.P.)........:Profile1
System Memory Multiplier (SPD)........:x8
Memory Frequency (Mhz).................:1,7XXMhz
DRAM Timing Selectable (sPD) ..........:Quick

>>>> CPU Voltages <<<<
LoadLine Calibration.....................isabled
CPU Vcore.................................:1.3625v
QPI/VTT Voltage.........................:1.28v
CPU PLL.....................................:1.800v

>>>> MCH/ICH Voltrage <<<<
PCIE.........................................:1.50 0v
QPI PLL.....................................:1.100v
IOH Core...................................:1.200v
ICH I/O.....................................:1.500v
ICH Core...................................:1.100v

>>>> Dram <<<<
DRAM Voltage............................:1.640v
Everything else is set to auto at the moment...

Advice welcome

~Bex

PS. @ Bluntsmoker - just for your amusement :P