I've decided to show the layout of future system while preparing case for powdercoating. As I am planning parts will be connected in the following order:
PA140.3 -> CPU block -> Motherboard -> EK Res -> GPU block -> pump MCP350 -> PA140.3
Any thoughts on this are highly appreciated




This Thermochill is really huge thing I've tryed to put it into the case through the front - there are small holders at the top of the drive bay that doesn't allow to fit the rad. I was able to fit the rad only through the top, but even then I have to widen case a little by my hands


The only thing I haven't decided yet is where the hell I should place all of my HDDs?? Currently I have 2 in raid0 and 1 for storage and plan to buy one more for raid and one more for the storage
may be it is finally time for SSDs?