** Official ** Gigabyte UD3 P45 Series -- EP45-UD3 / EP45-UD3R / EP45-UD3P

[One_Hertz]

First, it's imperative to discover your CPU Ref1, Ref2 and MCH Ref, if those settings are wrong MOBO will cycle-boot. Do you know how to set these settings in this board?

Cycle boots can also be the result of wrong mem timings, PL Level, short on the MB backplate (check with a DMM touch the cascade backplate to find any shorts this is common using phase change backplates), or overheating PWM area...

What BIOS your on?

I was going to play with those and figure them out, but it didn't want to play with me . Ok removing the battery for a few minutes didn't stop the cycle reboots... How do I make it stop this?

Edit: ripped apart my insulation to check and everything was flawless. Nothing is shorting, nothing is even slightly damp. I am too pissed off to keep doing anything so I will continue tomorrow.