Quote Originally Posted by kuebk View Post
Ok, thanks.

My current settings are:
FSB = 450
Strap = 400
MEM = 1200
A/B Skew = Auto
Timings = 5-5-5-15
tRFC = 60
Performance Level = 7
A/B Pull-ins = all disabled
vCPU = 1.375
vMCH = 1.45
vDDR = 2.4
Loadline Calibration = Enabled
Both Spectrums = Disabled

And I left my PC for overnight with Linx ran, got up few hours later to check how's Linx is doing and it got stuck at 47 loop out of 100 with some error, so I went back sleep without turning it off but when I got up few minutes later I saw BSOD on my LCD.

47 passes looks pretty good for me but I don't really know what I can adjust, should I mess with DREF? Or maybe with Skews?

I dunno why my PC god BSOD overnight in idle, yea you can say it was because LLC enabled, but till I started clocing my ram at 600 I was clocking it at 540 with LLC enabled and never got any random BSODs.
Your in the right strap and your running at right DDR speed to start experiencing random failures.

Try with Prime95 Blend mode and look where it fails. Is it always in small FFT's or is it in Large FFT's. Is it always the same core. Or is it just randomly like I have at 8 X 465MHz and DDR 1239MHz.

Did you use the CPU and NB Clock Skew?