X48 Rampage Formula Preview.

[kuebk]

LLC locks Vin = Vout for Vcc/Vtt at voltage regulator. So you don't get droop, it compensates for drop across the reg and traces, and boosts voltage between in and out. Thats all it does really.

IF llc gives you problems, you have a PSU which can't handle the extra stress, or a voltage reg on your board that can't handle it.

Linpack errors are usually GTL / DRAM clock skew related. Under heavy load that Linpack creates you experience greater clock shift, and jitter and if it is too much shift / jitter it'll be visible in Linpack.

Ok, thanks.

My current settings are:
FSB = 450
Strap = 400
MEM = 1200
A/B Skew = Auto
Timings = 5-5-5-15
tRFC = 60
Performance Level = 7
A/B Pull-ins = all disabled
vCPU = 1.375
vMCH = 1.45
vDDR = 2.4
Loadline Calibration = Enabled
Both Spectrums = Disabled

And I left my PC for overnight with Linx ran, got up few hours later to check how's Linx is doing and it got stuck at 47 loop out of 100 with some error, so I went back sleep without turning it off but when I got up few minutes later I saw BSOD on my LCD.

47 passes looks pretty good for me but I don't really know what I can adjust, should I mess with DREF? Or maybe with Skews?

I dunno why my PC god BSOD overnight in idle, yea you can say it was because LLC enabled, but till I started clocing my ram at 600 I was clocking it at 540 with LLC enabled and never got any random BSODs.