Quote Originally Posted by Leeghoofd View Post
I need to give more than 0.08 over the required voltage, my board's DDR3 Vdimm fluctates like hell... strange while the DR2 version is rock stable...

Eg with 1.65 Corsair 1600C8 I7 dimms I need to set 1.72 to get 1.65 in reality, with the OCZ 1.9 Dimms I need to set 2.04 to be stable at 1600mhz C7.

For 4gb I need 1.32-1.34Mch NB voltage at 500FSB-1600Mhz...I'm totally blocked at 580FSB Hyperpi Stable, I can boot higher (600FSB) but the rig is far from stable... same counts for my DDR2 board...

I keep MCH reference just a tad below 0.75, 0.7 is too low here



Static tRead Value [10] do you set that setting manually or is it still on AUTO ?
tx for the info.. adjusting..