i hope you don't mind .. but i find you design is not desirable .. well let's say your design has rooms for improvement and thoughts

1. the front intake fan is hrm .. too large .. somehow i looks bit rude and the circular mesh doesn not suit it .. how bout make it 120mm with the grill-like look added to the mesh?

2. the start/reset button can improve .. it's best to place in the area which is easier to access .. either top or bottom of the front fan intake and those usb ... use a less conspicuous area to place the usb/firecable/esata/audio ports as well ..

3. i think the top 5 1/2 slot ... you could pry out 2x 5 1/2in slot to place a LCD screen

4. since i suggested the top section to have another 5 1/2in slots ... then the back of it should have have an output as well .. in case of an additional PSU .. or a grill with 2 80mm fans outtake

5. i think the ventilation is going to be a problem ... intake 140mm .. outtake 120mm? maybe you could incorporate another 120mm at the top of the mobo?

6. the PSU slot .. the bottom suspending the psu .. i think it should be splitted to 2 bars only placed parallel side by side left & right (not front back) .. you might not know if you wish to place the psu bottom air intake

7. this is an alternative idea .. how bout getting 1x 120mm fan for the hard disk section ... and another 120mm fan for the bottom .. section .. means 2x 120mm fan .. try to make it with an adequate spacing .. and with a nice grill look ... i think rounded vertical gaps is quite sexy


i hope you don't mind those comments .. i just speak what's in my mind