Woo another update

So here's the front with the screen installed. It fits perfectly in front of the HDDs.


Here you can see the MCR220 I fit onto the back of the case. I had to cut out places for the fittings to go through the case as well as cut off the two grills built into the back to make it sit flush.


Here's a shot of the MCR220 from the inside to see the barbs fitting through. It's going to be tight but I think I can make it work.


And finally, here's a side shot of my case right now. See how none of the PSU cables actually are visible? I still need to work on the wire management a bit in places and sleeve what you can see but I think it's coming along great so far. Also I need to either buy or make extenders for the main 24pin ATX and 8pin mobo power cables because they don't reach that far =/


Thoughts?