Thank you!

Talked to the powder coaters today and the outcome was not too pleasing. The sheet metal worker said that It would be impossible to fix the panel perfectly. And he told me that the guys that would have lasercut a new panel for me was filled upp their asses with work, so it would take a long time to get it done. However, he offered me a 140$ compensation, a new piece of sheet metal, discounts if I would like to powder coat something in the future and a new free session of powder coat on the new outer panel.

So i have to fabricate a new panel which sucks.. will take about ~18 hours to fabricate a new one. But I'm going to try bending the old panel as good as possible and see if it can do as a temporary panel.

Any who., have finished the hardware and internal build to say 98%. It started up and is working great. Great temps and silence. Just got to do some sleeving etc. Anyways here are some extra large candy shots for ya'll. This time I'm going to let them speak for themselves.



















Again, THANK YOU for your support throughout the build so far

I don't know if you'll notice, but I skipped the internal cover and went with an open view. Wanted to see the pumps and wanted the case to be a bit more flexible. No bigge.