[Project] Water-Cooled HAF 932, Painted Satin Black

[xguntherc]

So, Like the above post, I got a lot done, but not many pics. I went ahead and got up this morning and did another coat of Satin Black at about 10 in the morning. around 1:30 I did some Wet Sanding with some 1000 grit paper, just lightly, nothing to severe. and then I let it dry, helped it with my Compressor of air.. haha. And then I did another coat, and so on.

So today I did 3 more coats, for a total of 5 coats to my CM HAF inside. It looks really good, and I think the sanding really helped smooth it out, so I don't have too much of that orange peel look to it. but I didn't do it to the last 2 coats. plus I'll use grease where you take the panel off to help with scratching.

Anyways, enough talking, Here are the pics.

My new RAD.. I'm exited.




Here are some pics of my Fans, like said above. I got the Yate Loon Medium speed fans, and I went ahead and sleeved all them today. I love the sleeve job, Looks so clean.



Close up on the sleeving.



And thats about it for now, I took a few more pics than that, but I'll have to do some editing in Lightroom tomorrow and remove some of the marks from the dust in the Sensor on my Nikon D40, to bad amazon's shipping is slow, or I'd have my sensor cleaner already. ;( I have to take all the shots at a low enough f/stop in order to not see the dust marks, but soon I'll have that fixed.

More pics to come tomorrow as I put the case back together.

Thanks for watching.

[rioja]

good sleeving on fans
may you show another end, near connectors?