Quote Originally Posted by NaeKuh View Post
actually you can pull them off... there sealed together with a thermal adhesive, and slip right off..

Now hole in the middle, i dont think you need to worry, because thats where a heat pipe would of gone... If you have good fans on that sink it will still keep your mosfets cold...

And you can put it back together, just use a thick tim, like AS5 and spread it back on the heat pipe and slide it right in....

Its a cheap solution that works... However if your getting full board blocks i dont think your holding a tight budget, so mosfet blocks should follow...
the rads of origin are stuck on the heat pipe, impossible to separate ....

a solution for the removed without problem?

thank you