Quote Originally Posted by Zeus View Post
I can't see wheter it's glued or welded but it's not possible to take the mosfetsink apart with srews or someting, i.e. it's not made to be taken apart.

Pulling the heatpipe out would leave a big gap in the sink that won't be helping cooling properties either.
actually you can pull them off... there sealed together with a thermal adhesive, and slip right off..

Now hole in the middle, i dont think you need to worry, because thats where a heat pipe would of gone... If you have good fans on that sink it will still keep your mosfets cold...

And you can put it back together, just use a thick tim, like AS5 and spread it back on the heat pipe and slide it right in....

Its a cheap solution that works... However if your getting full board blocks i dont think your holding a tight budget, so mosfet blocks should follow...