I just got my DFI x58 up and running, flashed BIOS to latest (Jan.6) here are some of the problems:

I can't get turbo mode. I enable Intel turbo in BIOS, but all four multi options are greyed out , e.g. "if all cores enabled, x21". When I boot into windows, CPUZ reports I'm at x20 multi, which means no turbo. How do I get the BIOS multis to not be greyed out, and how do I get Turbo to kick in once in windows.

I have configured my voltage and multis in BIOS to be same as my giga UD5 board, but with same settings and components, this board is a terrible OCer compared to my Giga board. Id there a trick I don't know about? my multis are 8/16/36 memory/QPI/uncore.
With the Giga board, it was very straightforward...adjust Vcore and Vtt and set multis and after that, it's just a matter of how good your chip is. But with the DFI, there are a number of mystery settings that I have no idea what they do. There are somethings I like about this board vs the giga but I'll have to send it back if I can't get it to be at least close to the giga in OC.

So in summary, how do I get Turbo mode to kick in, and what is the secret setting to make this board OC correctly?

3x 2GB Patriot 9-9-9 1600 Mhz viper
Tiniq Tower 120