Looking Good!

I’d love to see more pics of that pool.

If it’s not too late and you haven’t painted yet, you may want to drill a couple holes in the motherboard tray for cable management. I usually do them symmetrically at the top and bottom. You’ll likely find the bottom hole will be useful in passing the 8pin power to the mobo. The top can be used to pass internal USB cables to the mobo headers or other stuff. If you drill the holes just inside of the edge of where the motherboard sits, you won’t see them. The long standoffs will provide enough room to pass the wires.

A longish hole on the midplate, just to the side of where the rail goes and at the outer edge will also come in handy. One issue with the TJ07 is that without creating a hole on the backside of the midplate, you’re very limited in cable management options. To make this hole I use a large drill bit and pop 5-6 holes lengthwise; then I clean it up with a Dremel and hand file. It’s best to make this hole before riveting the rail in place.

Looking forward to your next update!