Nanofluid tested with three different temperatures on a Q6600

[skinnee]

How about pump bearing damage?

that was my brinell hardness response.. I will have to check on that. But, that is the way I am leaning.. I will let you know.

Nothing evident...and the same goes for Naekuh's request on the block internals, nothing evident. There was more build-up on the Fuzion V1 inlet (slight lip on the washer where the cover meets the mid-plate), but this is versus distilled which has absolutely no build-up.

The only major difference between distilled and nanofluid was the residue and build-up throughout the loop. Every component in the loop had residue or build-up from the nanofluid, including the funnel I used for filling.

I will be using more instrumentation on the next round of tests, thats for sure.