UNOFFICIAL BIOSTAR TPower I45 M/B

[dro]

hi guys

i jes got my tpower i45 yesterday
but having some prob migrating from dfi p35 t2rs

so on my dfi....i was able to do this



with these setting



and i was hoping be able to beat these setting





but wit the tpower
i can barely go pass 450x9.....and it only works at 1:1 mem divider

[BIOS SETUP] O.N.E
Over-Clocking Navigator [Manual OverClock]

Intel® SpeedStep™ : disabled
Ratio CMOS Setting : x9
CPU Frequency Setting : 450
Over Clock Retry Count : 3
FSB(Bsel) To NorthBridge Latch : 1333
DRAM Frequency : 900
DDR2 Enhance Mode : disabled

DRAM Timing Configuration
DDR2 RCOMP Configuration : 2
Static tREAD Value : 10t
Configure DRAM Timing by SPD : 5-5-5-15

Clock Gen Configuration
PCIE Frequency Setting : 100
CPU Clock Skew Control : auto
(G)MCH Clock Skew Control :auto
CPU Clock Driving Control :auto

Voltage Configuration
CPU Voltage : +0.025vv
DDR Voltage :+0.05v
Chipset Voltage : + 0.05v
FSB Voltage : +0.05v
CPU Core1 GTL Ref Voltage : .63
CPU Core2 GTL Ref Voltage : .67
MCH GTL Ref Voltage : auto
CPU PLL Voltage : 1.5

everytime i try to push harder
(by pumping up the V)
it would fail....and reset back to the default V
**based on hardware monitoring screen in the bios)
even though i keep on pumping the V
and this would only go away if i reload the profile that i successfully pushed before

so any of u guys care to comment/share some idea on what is going on wit my mobo?
is it spoilt? time for RMA?
or am i jes a terrible p45 ocer


***i know dat u guys will most prolly confuse urself after reading half way cuz im jes rambling on here without any screenshots......but im jes fedup wit this mobooooooooooo~~~~ ......sorryyyyy***