Quote Originally Posted by bito View Post
Any template with your complete settings please
Thanks and well done
Thanks mate. I struggled to get over 466 FSB initially - until I changed the GTL settings for the NB. That allowed me to get to 480. I was then found I couldnt prime blend at 490 (system would freeze) until I set the CPU and NB clock skew. Then I found that one core would drop out on prime - until I set the GTL 1 & 3. Now appears totaly stable will prime small fft & blend all day and will be in use at these settings 24/7.

Hope this info helps others.


Processor: Q9560
Ai Overclock Tuner: Manual
Ratio CMOS Setting: 9
FSB Frequency: 490
CPU Clock Skew: 200
NB Clock Skew: 100
FSB Strap to North Bridge: 333
DRAM Frequency: DDR2-980MHz

DRAM CLK Skew on Channel A1: AUto
DRAM CLK Skew on Channel A2: AUto
DRAM CLK Skew on Channel B1: AUto
DRAM CLK Skew on Channel B2: AUto
DRAM Timing Control: Auto (Gskil auto config to 5-5-5-15)

Common Performance Level: 10
Pull-in of CHA PH1: Disabled
Pull-in of CHA PH2: Disabled
Pull-in of CHA PH3: Disabled
Pull-in of CHB PH1: Disabled
Pull-in of CHB PH2: Disabled
Pull-in of CHB PH3: Disabled

PCIE Frequency: 100

CPU Voltage: 1.40(actual)
CPU PLL Voltage: 1.50
FSB Termination Voltage: 1.49
DRAM Voltage: 2.10
North Bridge Voltage: 1.45
South Bridge 1.5 Voltage: 1.50
South Bridge 1.1 Voltage: 1.10

CPU GTL Reference (0): Auto
CPU GTL Reference (1):-55mv
CPU GTL Reference (2): Auto
CPU GTL Reference (3):-55mv
NB GTL Reference: +60mv
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto


CPU Configuration:

Ratio CMOS Setting: 9
C1E Support: Disabled
Max CPUID Value Limit: Disabled
Intel Virtualization Tech: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled

Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled