Quote Originally Posted by Grnfinger View Post
going back to 701 is your rig stable again with same settings.

Why are you running PLL so high? I doubt it need to be set so high, I'm running 1.5 ( bios ) for 3.9GHz 459x8.5

DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : 3
Row Refresh Cycle Time : 55
Write Recovery Time : 6
Read to Precharge Time : 3

Read to Write Delay (S/D) : 8
Write to Read Delay (S) : 3
Write to Read Delay (D) : 5
Read to Read Delay (S) : 4
Read to Read Delay (D) : 6
Write to Write Delay (S) : 4
Write to Write Delay (D) : 6

Write to PRE Delay : 14
Read to PRE Delay : 5
PRE to PRE Delay : 1
ALL PRE to ACT Delay : 5
ALL PRE to REF Delay : 5


CPU Voltage : 1.35
CPU PLL Voltage : 1.50
FSBT : 1.33850
DRAM Voltage : 2.12
North Bridge Voltage : 1.39150
South Bridge Voltage 1.5 : 1.5
South Bridge Voltage 1.1 : 1.1

my
Yes it was stable with 701 bios. I raised the PLL voltage and that helped me get to 3.72. I will try lowering it and try your settings.
Quote Originally Posted by CryptiK View Post
Yes, I'm the one who asked him to do it for me by special request. It did help, I gained an extra 40MHz of stable ram speed. It didn't allow me to do what I was hoping for (650 MHz +) but there was definitely an improvement.

His modded bios also supports more cpu's than the latest M2F bios.

Gimme a minute I'll find the link for you Grnfinger.

EDIT - here: http://www.xtremesystems.org/forums/...&postcount=358


So just to clarify, every setting is the same, but it is no longer stable using bios 1307? I'd also like to know if going back to 701 gets you stable again at the same settings.
All settings the same. I went back to 701 and ran large FFT's but have not run "blend" yet. I felt that my settings were too high for the OC reached.