Hey guys I need your help. I was Prime95 "Blend" stable 2 hours with bios 701 and I flashed up to 1307 and it craps out in a matter of minutes now. Here are my settings, please look them over and make some suggestions. I am not trying to hit real high numbers just 3.7 for my daily machine. This chip is a "C0" revision and not the best clocker by any means. This is the machine in my sig.
Thanks.

PHP Code:
Ai Overclock Tuner: Manual
OC From CPU Level Up: Auto
Ratio CMOS Setting: 8.5
FSB Frequency: 436
CPU Clock Skew: Normal
NB Clock Skew: Normal
FSB Strap to North Bridge: Auto
DRAM Frequency: DDR2-1047MHz

DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Manual

1st Information: 

CAS# Latency: 5 DRAM Clocks
DRAM RAS# to CAS# Delay: 5 DRAM Clocks
DRAM RAS# Precharge: 5 DRAM Clocks
DRAM RAS# Activate to Precharge: 15 DRAM Clocks
RAS# to RAS# Delay:  Auto
Row Refresh Recycle Time: 55 DRAM Clocks
Write Recovery Time: Auto
Read to Precharge Time: Auto

2nd Information:

Read to Write Delay (S/D): Auto
Write to Read Delay (S): Auto
Write to Read Delay (D): Auto
Read to Read Delay (S): Auto
Read to Read Delay (D): Auto
Write to Write Delay (S): Auto
Write to Write Delay (D): Auto







3rd Information:

Write to PRE Delay: Auto
Read to PRE Delay: Auto
PRE to PRE Delay: Auto
All PRE to ACT Delay: Auto
All PRE to REF Delay: Auto
DRAM Static Read Control: Disabled
DRAM Read Training: Auto
MEM. OC Charger: Auto
Ai Clock Twister: Auto
Ai Transaction Booster: Manual

Common Performance Level: 10
Pull-in of CHA PH1: Disabled
Pull-in of CHA PH2: Disabled
Pull-in of CHA PH3: Disabled
Pull-in of CHB PH1: Disabled
Pull-in of CHB PH2: Disabled
Pull-in of CHB PH3: Disabled

PCIE Frequency: 101

CPU Voltage: 1.4250
CPU PLL Voltage: 1.61925
FSB Termination Voltage: 1.37825
DRAM Voltage: 2.14450
North Bridge Voltage: 1.35175
South Bridge 1.5 Voltage: 1.50
South Bridge 1.1 Voltage: 1.12650

CPU GTL Reference (0): Auto
CPU GTL Reference (1): -45mv
CPU GTL Reference (2): Auto
CPU GTL Reference (3): -45mv
NB GTL Reference: Auto
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto









CPU Configuration:

Ratio CMOS Setting: 8.5
C1E Support: Disabled
Max CPUID Value Limit: Disabled
Intel Virtualization Tech: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled

Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled