ASUS Striker II Extreme

[skinnee]

From BenchZowner's list...

Required System Specifications
PSU ( Power Supply Unit ) = Silverstone DA1200
CPU = Q9450
RAM = G.Skill DDR3-12800 CL7 2x@GB
HDD ( the one where you have your windows installation on ) = Seagate  ST3250310NS Barracude ES.2 250GB
VGA1 = eVGA 9600GT
VGA2 ( if you have ) =
VGA3 ( if you have ) =
SPU ( Sound Card ) = Supreme FXII
NorthBridge Cooling = Stock
SouthBridge Cooling = Stock
CPU Cooling = Intel HSF
RAM Cooling = Corsair Dominator Fans
nFORCE Chipset Drivers Version =
ForceWare/GeForce Drivers Version =
Sound Card Drivers Version =
BIOS version =  0801

BIOS Settings
Extreme Tweaker
CPU Level Up = Auto
Memory Level Up = Auto
AI Overclock Tuner = Manual
CPU Multiplier = 8.0
FSB - Memory Clock Mode = Linked
FSB - Memory Ratio = Sync Mode
FSB (QDR) MHz = 1600
MEM (DDR) MHz = 1600
LDT Frequency = 5x
PCIE Bus Slot 1 & 2 MHz = 100
PCIE Bus Slot 3 MHz = 100
SPP<->MCP Ref Clock, MHz = Auto 
SLI-Ready Memory = Disabled

Memory Timing Setting
P1 = Enabled
P2 = Enabled
tCL ( CAS Latency ) = 7
tRCD = 7
tRP = 7
tRAS = 18
Command Per Clock (CMD) = 2T
tRRD = (Auto) 5
tRC = (30) 30
tWR = (Auto) 12
tWTR = (Auto) 18
tFAW = (Auto) 25
tRD = (13) 13
tRTP = (15) 15
tRFC = (251) 88
tREF = (Auto) 7.8uS

Over Voltage
CPU Voltage = (Auto)
Loadline Calibration = Enabled
CPU PLL Voltage = (Auto)
CPU VTT Voltage = (Auto)
Memory Voltage = 1.90V
NB Core Voltage = (Auto)
SB Core Voltage = (Auto)
CPU GTL REF0 Ratio = (Auto)
CPU GTL REF1 Ratio = (Auto)
CPU GTL REF2 Ratio = (Auto)
CPU GTL REF3 Ratio = (Auto)
NB GTL REF Ratio = (Auto)
DDR3 CHA1 Ref Volt = (Auto)
DDR3 CHB1 Ref Volt = (Auto)
DDR3 CHA2 Ref Volt = (Auto)
DDR3 CHB2 Ref Volt = (Auto)

CPU Configuration
CPU Internal Thermal Control = (Auto)
Limit CPUID MaxVal = Disabled
Enhanced C1 (C1E) = Disabled
Execute Disable Bit = Disabled
Virtualization Technology = Disabled
Enhanced Intel SpeedStep(tm) Tech. = Disabled
CPU Core 2 = Enabled
CPU Core 3 ( Ignore this setting, unless you have a Quad-Core CPU ) = Enabled
CPU Core 4 ( Ignore this setting, unless you have a Quad-Core CPU ) = Enabled

Spread Spectrum Control
CPU Spread Spectrum = Disabled
PCIE Spread Spectrum = Disabled
MCP PCIE Spread Spectrum = Disabled
SATA Spread Spectrum = Disabled
LDT Spread Spectrum = Disabled