Yes, the 2x2GB 12800CL7.Originally Posted by skinnee
Which RAM again, I don't remember what you listed off earlier.
If you have G.Skill 12800CL7, then I can say 2x2GB works with Vista x64. I haven't tested RAID yet, I have some vacation time coming up for that testing.
Here is where I am sitting thus far, can't push everything too hard as I am still getting the cooling setup, soon enough I'll be able to push to the FSB wall. What I listed here is the only things I have changed from Auto. Proc is a Q9450
Clock Mode: Linked
Ratio: Sync Mode
FSB (QDR): 1720
P1: Enabled
P2: Enabled
tCL: 8
tRCD: 8
tRP: 8
tRAS: 20
CMD: 2T
Voltage: 1.9v
Another place that I BSoD on install is when I try to provide it with a driver for the disk controller (with the raid controller on or off), and I eject the disc. At the moment I push the eject button, it crashes. Which is why I don't think it is RAID that is doing this.
I will however try to do it without RAID enabled.
So, you do have the G.Skill 2x2GB 12800 7-7-7-18 1.9V RAM kit with a Striker II Extreme?
Could you post all your settings?
If it is bad hardware: Do you think the RAM is bad, even though ramtests say it is fine? Or perhaps my motherboard is bad?
Reply With Quote
Bookmarks