I have flashed all my 1600 modules with the new SPD files Tony made and still cant get it to work at 1600, been trying for 12 hours straight. Just isn't fun anymore. It works perfectly at 1333 with the new flash, I will say that. Boots right up with ratio set to AUTO and timings set to BY SPD. Hell, I have it running right now at 4.3GHz 13x333 with those set to auto. So, I'll just wait for a few more bios upgrades, hopefully that will straighten it out some.
I do have a note of strangness for you SAAYA. The RATIO +0.5 Enable doesnt seem to be working right, on my MB anyway. If it is set to DISABLE, then CPUz & OCCT show what its set too and SuperPi runs at the speeds it should for a 1M calculation. But if I set 0.5 to ENABLE then the CPU sets itself to 9x333 as per CPUz & OCCT and SuperPi 1M runs at 9x333 speed, which on my MB is 15 sec. Check out these screenies for the different bios settings. Maybe should be looked at?
(Edit - this is the G27 Bios)
(Edit - Its not settings the FSB back to 333, it stays where its set too, it's just reverting the multiplier back to 9x when you enable the 0.5 Ratio, in windows. Posting screen shows it set to the .5 and the speed also)
Top Left Pic - Bios set to 12x333, Ratio Disabled
Top Right Pic - Bios set to 12x333, Ratio Enabled
Bottom Left Pic - Bios set to 13x333, Ratio Disabled
Bottom Right Pic - Bios set to 13x333, Ratio Enabled
Reply With Quote
Bookmarks