Quote Originally Posted by gandalfone View Post
Wow eva2000 that nice work!!
can you provide bios version and settings you used for those clocks ?

27/07/07 Bios template:


Use this template to share your DFI UT P35-T2R bios settings

CPU Feature
- Thermal Management Control: Disabled
- PPM(EIST) Mode: Disabled
- Limit CPUID MaxVal: Disabled
- CIE Function: Disabled
- Execute Disable Bit: Disabled
- Virtualization Technology: Disabled
- Core Multi-Processing: Enabled

Exist Setup Shutdown: Mode 2
CLOCK VC0 divider: AUTO
CPU Clock Ratio Unlock: Enabled
CPU Clock Ratio:
- Target CPU Clock:
CPU Clock:
Boot Up Clock:
DRAM Speed:
- Target DRAM Speed:
PCIE Clock: 100mhz

Voltage Settings
CPU VID Control:
CPU VID Special Add:
DRAM Voltage Control:
SB 1.05V Voltage:
SB Core/CPU PLL Voltage:
NB Core Voltage:
CPU VTT Voltage:
Vcore Droop Control: Enabled
Clockgen Voltage Control: 3.45v
GTL+ Buffers Strength: Strong
Host Slew Rate: Weak
GTL REF Voltage Control: Disable
x CPU GTL1/3 REF Volt: 110
x CPU GTL 0/2 REF Volt: 110
x North Bridge GTL REF Volt: 110

DRAM Timing
- Enhance Data transmitting: AUTO
- Enhance Addressing: AUTO
- Channel 1 CLK fine delay: AUTO
- Channel 2 CLK fine delay: AUTO

CAS Latency Time (tCL):
RAS# to CAS# Delay (tRCD):
RAS# Precharge (tRP):
Precharge Delay (tRAS):
All Precharge to Act: AUTO
REF to ACT Delay (tRFC): AUTO
Performance Level: AUTO
MCH ODT Latency: AUTO
Write to PRE Delay (tWR): AUTO
Rank Write to Read (tWTR): AUTO
ACT to ACT Delay (tRRD): AUTO
Read to Write Delay (tRDWR): 8
Ranks Write to Write (tWRWR): 6
Ranks Read to Read (tRDRD): 6
Ranks Write to Read (tWRRD): 5
Read CAS# Precharge (tRTP): AUTO
ALL PRE to Refresh: AUTO

PCIE Slot Config: 1X 1X
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
SATA Spread Spectrum: Disabled