**Official DFI LanParty UT P35-T2R Review/Overclock/Guide Thread**

[gandalfone]

Wow eva2000 that nice work!!

I set the parameter in bios(channel 2 clock fine delay 13 instead 14/auto) and the ram go like p5k dlx....nice
Here 2 spi32M with identical O.S.
Last official bios
Teamgroup 9600

P5k dlx spi32M




DFI P32 TR




BIOS SETTING

CPU Feature
- Thermal Management Control: Disabled
- PPM(EIST) Mode: Disabled
- Limit CPUID MaxVal: Disabled
- CIE Function: Disabled
- Execute Disable Bit: Disabled
- Virtualization Technology: Disabled
- Core Multi-Processing: Enabled

Exist Setup Shutdown: Mode 2
CLOCK VC0 divider: AUTO
CPU Clock Ratio Unlock: Enabled
CPU Clock Ratio:7
- Target CPU Clock:3605
CPU Clock:515
Boot Up Clock:auto
DRAM Speed:266/667
- Target DRAM Speed:1206
PCIE Clock: 110mhz

Voltage Settings
CPU VID Control:1.365
CPU VID Special Add:auto
DRAM Voltage Control:2.47
SB 1.05V Voltage:1.217
SB Core/CPU PLL Voltage:1.95
NB Core Voltage:1.74
CPU VTT Voltage:1.38
Vcore Droop Control: Disabled
Clockgen Voltage Control: 3.75v
GTL+ Buffers Strength: Strong
Host Slew Rate: Weak
GTL REF Voltage Control: Disable
x CPU GTL1/3 REF Volt: 110
x CPU GTL 0/2 REF Volt: 110
x North Bridge GTL REF Volt: 110

DRAM Timing
- Enhance Data transmitting: FAST
- Enhance Addressing: FAST
- Channel 1 CLK fine delay: CURRENT[14]
- Channel 2 CLK fine delay: 13

CAS Latency Time (tCL): 5
RAS# to CAS# Delay (tRCD):4
RAS# Precharge (tRP):4
Precharge Delay (tRAS):12
All Precharge to Act: AUTO
REF to ACT Delay (tRFC): AUTO
Performance Level: AUTO
MCH ODT Latency: AUTO
Write to PRE Delay (tWR): AUTO
Rank Write to Read (tWTR): AUTO
ACT to ACT Delay (tRRD): AUTO
Read to Write Delay (tRDWR): AUTO
Ranks Write to Write (tWRWR): AUTO
Ranks Read to Read (tRDRD): AUTO
Ranks Write to Read (tWRRD): AUTO
Read CAS# Precharge (tRTP): AUTO
ALL PRE to Refresh: AUTO

PCIE Slot Config: 1X 1X
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
SATA Spread Spectrum: Disabled


The subtiming are setting with memset