Quote Originally Posted by shimmishim View Post
When I clear the CMOS, the voltages all go back to default.

Even with 1 stick in any slot (1-4) will not allow the board to boot.

It gets to the boot logo screen and then gets stuck there. It will not allow me to enter the bios.

I am sure it has to do with the SPD programing on the sticks. It attempts to boot the sticks at ddr2-1000 at board default voltage of 1.8, not 2.2.

If i stick in my crucial ballistix which are spd programed to boot up at 5-3-3 ddr2-667, i can get into the bios, change voltage to 2.2, remove them and then stick in the HZ's and they boot up fine.
yeah that is totally voltage problem
do you want us to reprogram it? i can do that for you or just use SPD tool to do it by you self is good
just need to becareful