Quote Originally Posted by G.S Technician View Post
it is just not boot up or totally bad?
When I clear the CMOS, the voltages all go back to default.

Even with 1 stick in any slot (1-4) will not allow the board to boot.

It gets to the boot logo screen and then gets stuck there. It will not allow me to enter the bios.

I am sure it has to do with the SPD programing on the sticks. It attempts to boot the sticks at ddr2-1000 at board default voltage of 1.8, not 2.2.

If i stick in my crucial ballistix which are spd programed to boot up at 5-3-3 ddr2-667, i can get into the bios, change voltage to 2.2, remove them and then stick in the HZ's and they boot up fine.