Quote Originally Posted by individual View Post
OK I'm doing the motherboard tray, which is BY FAR the most complicated part of the design.
A few things I've discovered, the rear IO mount (where the I/O shield clips into) can be a maximum of 1.32mm thick and a minimum of .93mm thick. So I'll have to change that to 1mm material.

I have to ask, I can find all the details I need for the HTPX form factor mounting holes and I/O shield, but I can't find any details on PCI mounting :/

I'm after the PCI tabs that slot into the mobo tray, their placement in relation to the motherboard mounting holes, and of course the dimensions of the PCI slots, and placement of the screw holes. basically everything PCI I still need. Most of your dimensions are solid, but I want to double check everything especially when things start to get made.
Well if you have the exact dimensions of a 10 slot I/O shield you should be fine. Fix the I/O shield to the rear of your case and then start to place the motherboard holes from there (if you know the motherobard I/O measures. If you do not have the complete measures of a 10 slot I/O shield I think I could give you a help. I think I have them in SolidWorks and I'm also waiting for a 10 slot I/O shield from danger den which should be ideal for your needs, I could measure it for you.

Also, check out www.grabcad.com and I'm sure you can find a correct I/O shield there

I'll try to send you a couple of measures as soon as I get home. Can I ask you if you'll be so kind to share HPTX form factor mounting holes here or via PM? I really need them

Thank-you