Hi guys jus checkin i did things right.
Backup Bios = F8 (OC setting allready set)
Main bios flashed thru Q-flash in bios to F10x not @-Bios (should i have done?)
--- Things i disable when i OC.. Marvel ports, Audio, Wake on LAN, firewire, C1/C3
--- Enable or disable Intel Virtualization tech. (Does this help in any way?)
Everthin flashed fine...rebooted..I always press ESC to go into Advanced bios then F7 to load defaults..Enter...then F10 to Save n Exit..reboots shuts down once as allways then checked bios version F10x correctly displayed. Im sure Dram was showing 1.35V i then booted into windows...
Shutdown...CLR onboard CMOS
Enter Bios Dram showed 1.66 or 1.65 v which i think has allready been logged. I then went on to change to my OC settings. I set dram to 1.5v 2133 10 10 10 28 & 30 1N set VTT IMC (1.095v 1.1v) also tried (1.145 1.150)
Got the deadly beeps lots of boot loops. Then i noticed my dram voltage stuck on 1.47v (this is setting from backup bios) no matter what i select the voltage never changed. I did try 2 x 4GB 2133 which worked (tried HCI memtest no errors) 4 sticks givs me errors in 2 secs
Is F10x for Sammy + IVY only?? should it work with SB aswell ??
I know my max wud be DDR 2133 id be happy with that. Currently on 1866 9 9 9 27 1n no probs.
Need to check the following::
Does both Backup & Main have to be on F10x for the sammy fix to work??
Is Q-Flash the best way to flash ? (ive never had issues with this method)
Voltage for DDR 2133 10 10 10 28 1N is 1.5V ok ??
Any help wud be greatly appreciated.
Reply With Quote
Bookmarks