** Official ** Gigabyte UD3 P45 Series -- EP45-UD3 / EP45-UD3R / EP45-UD3P

[prtuc2]

Recently I transfer my parts to a new case and then my problem starts from here. The problem is that my motherboard Gigabyte P45 UD3P rev 1.1 can no longer boot with 2 sticks of ram. I own this board over 2 years already and this time I just can't get it to boot no matter what I did, clear CMOS, unplugging the power cord. As right now I am booting on the first DIMM slot and both ram is working.

At first I thought it was the ram so I RMA the ram, but today got the new ram same problem acting out. Any suggestions would be greatly appreciated.


Code:

******Motherboard Intelligent Tweaker (M.I.T.)******

Robust Graphics Booster.........................[ Auto ]
CPU Clock Ratio.................................[ 9.0 ]
Fine CPU Clock Ratio............................[ + 0.0 ]
CPU Frequency 4.0GHz............................[ 333 x 9.0]

******Clock Chip Control******

CPU Host Clock Control..........................[ Enabled ]
CPU Host Frequency (Mhz)........................[ 333 ]
PCI Express Frequency (Mhz).....................[ Auto ]
C.I.A 2.........................................[ Disabled ]


******DRAM Performance Control******

Performance Enhance.............................[ Standard ]
(G) MCH Frequency Latch.........................[333 ]
System Memory Multipler.........................[ 3.2 ]
Memory Frequency 1066...........................[ 1066 ]
DRAM Timing Selectable..........................[ Manual ]

CAS Latency Time................................[ 5 ]
tRCD............................................[ 5 ]
tRP.............................................[ 5 ]
tRAS............................................[ 15 ]

******Motherboard Voltage Control******

Load-Line Calibration...........................[ Enabled ]
CPU Vcore [ 1.2125 ]......................[ 1.2125]
CPU Termination [ 1.20 ]...................[ 1.200 ]
CPU PLL [ 1.50 ]...................[ 1.500 ]
CPU Reference [ 0.760 ]...................[ 0.760 ]

MCH Core [ 1.100 ]...................[ 1.100 ]
MCH Reference [ 0.760 ]...................[ 0.760 ]
MCH/DRAM Refernce [ 0.900 ]...................[ 0.890 ]
ICH I/O [ 1.500 ]...................[ 1.500 ]
ICH Core [ 1.100 ]...................[ 1.100 ]

DRAM Voltage [ 1.800 ]...................[ 2.00 ]
DRAM Termination [ 0.900 ]...................[ 0.890 ]
Channel A Ref [ 0.900 ]...................[ 0.890 ]
Channel B Ref [ 0.900 ]...................[ 0.890 ]

******Advanced BIOS Features******

Limit CPUID Max to 3............................[ Disabled ]
No-Execute memory Protect.......................[ Disabled ]
CPU Enhance Halt (CIE)..........................[ Enabled ]
C2/C2E State Support............................[ Disabled ]
C4/C4E State Support............................[ Disabled ]
CPU Thermal Monitor.............................[ Disabled ]
CPU EIST Function...............................[ Enabled ]
Virtualization Technology.......................[ Enabled ]