***Asus Rampage III Extreme Owners Thread***

[Tergon]

There you go guys all that low voltage and stable still

You can probably get around the swap issue by enabling diagnostic startup using MSCONFIG.

I think Andreezy is spot on, you probably do not have enough vCore. 1.38v is very low for 4.4GHz... A bit more volts there would most likely do you good.

With 12GB Ram, 1.25v QPI also seems low to me... Generally the rule I've been following is set QPI to 1.35v and then see how high your UCLK can go.

For 143 BCLK, you don't need to increase PCIE speed, 100 should be fine.

Lastly, your IOH is high. I use 1.2v IOH for 200BCLK with 2x GTX560 Ti's in SLI.